1. Switch to processing sequence iiiTUTSEQ07, which should still be open in the editor.
  2. Select the Variables tab and drag and drop the following variables onto the Processsing Sequence Parameters tab
    · ATTACHMENT
    · ATLOOPINDEX


  3. Check that both parameters are defined as Outbound. If necessary select this column for one of the parameters and use the drop-down provided to select Outbound.

  4. Select the View / Refresh menu option so that the new processing sequence, iiiTUTSEQ07A will be shown in this open processing sequence.4.  In the editor for processing sequence iiiTUTSEQ07, select the Processing sequences tab, and drag and drop iiiTUTSEQ7A into the sequence inside the LOOP directive.

    Focus on the Else which follows the LOOP before performing the drag and drop. This should ensure the processing sequence is added in the correct place. If necessary use the Promote and Demote buttons to position the execute processing sequence correctly.



    Your processing sequence should look like the following:



  5. Save processing sequence iiiTUTSEQ07.